The product will still achieve good opacity in 2 coats over a similar colour, although deeper colours may require a third coat.Īs Garden Shades often goes on directly to the wood, without a primer, sometimes it will soak deep into the wood and this can create the need for a third coat. As its sprayable, it also needs to be of low viscosity and will be runnier than other traditional paints. It is free-flowing to enable a smooth finish that gets into all the gaps and allows the profile of the wood to be a maintained. Garden Shades is a relatively thin and slack product by design. I have purchased Garden Shades and it seems extremely runny and watery. Any overspray should be cleaned up immediately (whilst still wet) with water and household detergent. Cover any nearby surfaces in case of overspray. #FINISHED PURPLE HEART WOOD FULL#Refer to the Sprayer user guide for full instructions before every use. Stir thoroughly before pouring contents into the Cuprinol sprayer. Brush on product, evenly, along the grain. Make sure wood has been pre treated with appropriate wood preserver to prevent wood and decay.Ĭoverage can vary depending on application method and the condition and type of surface. If adhesion is inadequate on previous coatings, lightly sand before application. The final colour will vary depending on the surface and number of coats. IF NOT POSSIBLE, LIGHTLY SAND DOWN SURFACES BEFORE RECOAT TO ENSURE ADHESION.Īpply in dry conditions, above 5 degrees Celsius and when bad weather is not forecast, minimum of 2 coats required. SUBSEQUENT COATS MUST BE APPLIED ON THE SAME DAY NO LONGER THAN 8 HOURS APART.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |